- Seen : 85 View
1. The product should be promptly closed if there is leaking water;
2. In a timely manner, We recommend user to replace the filter according to replacement cycle;
3. When the water suddenly becomes considerably larger flow, Please do not drink the water;
4. Please do not customize repair or alter the product;
5. When moving the product, please do not pull the PE pipe to prevent leakage;
6. When the product is not used for a long time, turn off the water supply, power supply;
7. Do not use the rated voltage power that disproportionate;
8. After first time use it or a short time (within 1 month), when start to use itm, first two tanks of produced water should be drained; after long-term (over 1 month) stopped use it, when start to use again, should replacement activated carbon filter;
9. Use detergent to scrub it, please do not to use gasoline, alcohol and other solvents to
Installation Note:
1. Do not install under sunlight;
2. The product working temperature 5 to 45 degrees;
3. The product can not filter hot water, please do not connect to water heater.
4. Before use it, installation of the product should be fixed to prevent product
turn down;
5. If the tap water pressue is higher than 0.4Mpa, please install the pressue
limiting valve before the product;
6. Do not arbitrarily remove the parts on the product, to prevent leakage and damage
to the machine;
7. PE pipe and fittings should installed in place;
8. Water tee, no seals should be wrapped with raw materials, there is a ring of raw
materials can not be wrapped around the band;
9. After the installation is completed, you should turn on the water and gooseneck
faucet, after 5 minutes, close gooseneck faucet , and check there leaks;
10. Pure water end and wastewater end can not be inversely connected.
OEM Policy:
We can print your LOGO and custom packaging of our products, if you order exceeds 1000 units or above;the imprinting service and packaging will be free, otherwise it will be charge for printing and packaging at cost. The procedure is very simple;after choosing the product, you must provide us your LOGO/Packaging ARTWORK(digital format PSD,AI),and we will send you back a visual of the labeled product. If you accept the size and position, we will proceed to mass production.
Packing: in cartons.
Delivery: within 15-20 days after receiving the payment.
MOQ: 1 Set.
Payment terms: L/C.T/T.Western union.
We can accept OEM or ODM.
Saler Company Information
