- Seen : 472 View
The application of the collector is in the plumbing of steam and hot water installations, in other words, the act of collecting steam or hot water from one or more producers and dividing it to one or more consumers is done by the collector.
The material used in the body is 17mn4 alloy and ST35.8 tube.
The steam collector in different sizes has inlets and outlets with different sizes according to the type of use, capacity and number of consumers.
Task: collecting and distributing steam from the producer to the consumer according to the size of the producer and consumer of steam or the steam produced from one producer for use by several consumers
Inlet size: It is usually the same as the outlet size of the boiler
Output size: It is variable and proportional to the size of the main steam line and consumers, as well as the number of consumers.
All inlets and outlets use special steam valves with steel discs.
Used flanges: PN16.
The bolts and nuts used are made of galvanized steel.
The used sheet varies from 10 mm to 25 mm in thickness according to the capacity, size and working pressure of the collector.
All parts are made with special welding wires and non-destructive tests on them.
The inside of the collector is fully restrained to neutralize the pressure inside.
Collector insulation: compressed glass wool with aluminum coating, which prevents water penetration into the glass wool and heat loss.
Covering the collector: steel sheet from the beginning to the end of the work.
Collector: It has a safety valve to prevent possible accidents and overload
One of the advantages of this device is to be equipped with an analog thermometer to observe the current steam temperature and also equipped with a manometer to observe the current steam pressure.
This collector is equipped with a steam trap or trap to automatically transfer the water resulting from the steam condensate in motion from inside the collector to condensate. This can be done
This collector has a support base for easier installation, and all parts, washers, and flanges are pre-planned and installed on the device for ease of piping.
Saler Company Information
